Because of the low profile nature of elastomer based connector, Shin-Etsu MT type is widely adopted for the functional testing of high frequency semiconductors devices. MT type offers 1.0mm (typical) short signal path that yield RF characteristics unmatched by mechanical connector. As for reliability, our unique capabilities produce distinctive wire placement that make certain the multiple touch downs. From SAW filter to large CPU, MT type is the ideal test contact solution.
		To inquire about products, check the checkbox, and then press the below button. checkmarks
		FEATURES MT-type series are anisotropic conductive sheet type, which consists of soft silicone rubber and of gold-plated metal filaments embedded densely into it. This type of Inter-Connector is suitable for inspecting and connecting IC packages such as BGA, QFP or SOP. Since MT-4X type has 4-time metal density, it can be used to CSP. Especially, MT series are superrior in transmitting high cycle. FEATURES Tip of wire is protruded from the base elastomer for 20um and Ni/Au plating was done to improve contact. Initial contact start at very low compressed stage thus reduce mechanical strain on device under test. Comparing to MT-T type, MT-P type has much improved durability (Depend on device type) FEATURES MAF-type Inter-Connector consists of multiple rows of metal fibers arranged symmetrically in a sheet of silicone rubber. This type is the thinnest of metal connectors. Various shapes are available because of punch-out manufacuturing method applied. MAF-type connectors are used for extensive applications including assembly or inspection device.